Protoshield KIT for Arduino / Freeduino

The Arduino Protoshield is a Shield board that sits on top of a standard Arduino board. More information.

This design has a few good features:

power busses for +5V and GND in middle of board

central bus can be configured to carry +5V, GND, neither, both (jumpers)

Special horizontal 5-pin bus to install pin headers for external connections.

2x5 IDC connector area for external connections.

holes connected in groups of five, breadboard-style

all regular Arduino pins accessible on top

bottom of board cannot short to USB connector as in other protoshield designs

power LED and reset button on top

USB/External power jumper accessible with protoshield installed

low parts count: only one capacitor, a resistor, and LED and a switch, in addition to header pins.

two ways to use it: add header pins and a breadboard on top, or just use through holes to wire point to point.